Configuring Route Mode
Configuring Route Mode
Problem:
This article applies to ScreenOS 4.0 and higher.
To configure your NetScreen device in Route mode, perform the following steps:
Before performing the following steps, you will need to configure the manage IP to manage your NetScreen-25/50/204/208. For more information on how to configure a manage IP address, go to Configuring a Manage IP Address on Juniper Networks NetScreen Device.
Open the WebUI. For more information on accessing the WebUI, go to Accessing Your NetScreen Using the WebUI.
From the NetScreen options menu, click Network, and then click Interfaces.
From the Trust interface, click Edit.
From the Interface page, enter the IP Address and Netmask desired for the Trust zone.
For this example, we have entered 192.168.1.1 and 24.
From Interface Mode, click to select Route.
Click OK.
From the Untrust interface, click Edit.
From the Interface page, click to choose Obtain IP using PPPoE, Obtain IP using DHCP, or Static IP.
For this example, we have selected Static IP, and we have entered an IP Address/Netmask of 1.1.1.1/28.
Click OK.
Troubleshooting
