Accessing the Command Line Interface Using Telnet

To access the command line interface using telnet, perform the following steps:

Access a command prompt. For more information on accessing a command prompt, go to Accessing a Command Prompt.

From the prompt, enter telnet and your trust interface IP address. Press ENTER.

The default IP address for the Trust interface of your Juniper firewall device is 192.168.1.1.

From the Remote Management Console screen, enter your login. Press ENTER.

The default login and password is netscreen. Both the login and password are case-sensitive.

From the password prompt, enter your password, and then press ENTER.

The password is based on keystrokes. For security purposes, the password is not displayed as it is entered.

Installation