Configuring a Policy for Dial Up VPN
Knowledge Base ID: KB4117
Version: 5.0
Published: 07 Oct 2008
Updated: 07 Oct 2008
Categories: . Firewall/IPSec_VPN
. IPSec
. ScreenOS

Synopsis:
Configuring a Policy for Dial Up VPN

Solution:

To configure a policy for dial up VPN, perform the following steps:

Step one: Open the WebUI. For an example of how to access the WebUI, consult:  KB4060 - Accessing Your NetScreen, SSG, or ISG Firewall Using the WebUI

 

Step two: From the Juniper Firewall menu, click Policies.

Image of step step two

Step three: From the Policies page, in the From drop-down menu, click to select Untrust, and in the To drop-down menu, click to select Trust.

Image of step three and four

Step four: Click New.

Step five: From Source Address, in the Address Book drop-down menu, click to select Dial-Up VPN.

Image of step five

Step six: From Destination Address, in the Address Book drop-down menu, click to select Internal Net. For more information on configuring an address book entry for the internal network, go to Configuring an Address Book Entry for the Internal Network.

Step seven: From the Action drop-down menu, click to select Tunnel.

Image of step six and seven

Step eight: From the Tunnel drop-down menu, click to select dialupvpn1. For more information about configuring a dial up VPN user, go to Configuring a Dial Up VPN User.

Step nine: Click to select Position at Top.

Image of step eight and nine

Step ten: Click OK.

Purpose:
Troubleshooting