NetScreen-25/50 Interfaces
NetScreen-25/50 Interfaces
Problem:
This article applies to ScreenOS 4.0 and higher.
The configurable interfaces available on your NetScreen-25/50 are as follows:
| Interface Type | Description |
| Ethernet | These interfaces are denoted by a physical port on the module. Although each interface is bound to a security zone by default, you can bind it to another zone as required. |
| Ethernet1 Bound to the Trust security zone by default. Connect to this interface using a twisted pair cable with RJ-45 connectors. | |
| Ethernet2 Bound to the DMZ security zone by default. Connect to this interface using a twisted pair cable with RJ-45 connectors. | |
| Ethernet3 Bound to the Untrust security zone by default. Connect to this interface using a twisted pair cable with RJ-45 connectors. | |
| Ethernet4 Bound to the Null zone by default. Connect to this interface using a twisted pair cable with RJ-45 connectors. | |
| Layer-2 | vlan1 Specifies a logical interface used for management and for VPN traffic termination while your NetScreen-25/50 is in Transparent mode. |
| v1-trust Specifies a logical Layer-2 interface bound to the V1-Trust zone. | |
| v1-untrust Specifies a logical Layer-2 interface bound to the V1-Untrust zone. | |
| v1-dmz Specifies a logical Layer-2 interface bound to the V1-DMZ zone. | |
| Tunnel | tunnel Specifies a logical tunnel interface. This interface is for VPN traffic. |
Installation
