This article provides the steps for configuring mobility-domain via the RingMaster.

Perform the following steps to configure mobility-domain via the RingMaster:

 1. Login to the RingMaster.

 
2. Select Upload WLC in the right corner to upload the primary controller.







 
3. Repeat step 2 to and specify the IP address of the secondary controller.

4. After uploading both the primary and secondary controllers into the RingMaster, select the Configuration tab, and then click on the Create Mobility Domain option.


 

5. Enter the Mobility Domain Name.


 

6. Choose the controllers to add into the mobility-domain.

7. Assign the Primary Seed and Secondary Seed for the mobility-domain. Then click Finish.

8. After creating the mobility-domain, select the Devices tab. Click on the Review option which is available on the right-hand side task panel to review the local changes. Similarly, Click on the Deploy option which is available on the right-hand side task panel to deploy the local changes.

9. Repeat step 8 (review and deploy) for the secondary controller.

10. Once the mobility-domain has been configured, we can verify the deployment from the CLI with the following command:

800R223# sh mobility-domain
Mobility Domain name:  ABC
Flags: u = up[2], d/e = down/config error[0], c = cluster enabled[0],
       p = primary seed, s = secondary seed (S = cluster preempt mode enabled),
       a = mobility domain active seed, A = cluster active seed (if different),
       m = member, y = syncing[0], w = waiting to sync[0], n = sync completed[0],
       f = sync failed[0]
Member: * = switch behind NAT
 
Member            Flags  Model     Version     NoAPs  APCap
----------------  -----  --------  ----------  -----  -----
10.9.221.223      upa--  MX-800R   9.0.9.2         2     16
10.9.221.233      us---  WLC880R   9.0.9.2         0     16