Support Support Downloads Knowledge Base Case Manager My Juniper Community

Knowledge Base

Search our Knowledge Base sites to find answers to your questions.

Ask All Knowledge Base Sites All Knowledge Base Sites JunosE Defect (KA)Knowledge BaseSecurity AdvisoriesTechnical BulletinsTechnotes Sign in to display secure content and recently viewed articles

[WLC] How to enable SNMPv3 in Juniper WLC using command line

0

0

Article ID: KB35587 KB Last Updated: 22 Mar 2020Version: 1.0
Summary:

This article provides the steps to enable SNMPv3 in Juniper Wireless Controllers (WLCs) so as to monitor them from a Simple Network Management Protocol (SNMP) server.

 

Solution:

To enable SNMPv3 in WLC using command line, perform the following:

  1. Log in to WLC by using SSH or Telnet via Putty.

  2. Enter the following command from Enable mode:

# ‚Äčset snmp usm snmpv3 snmp-engine-id local access notify-read-write auth-type sha auth-pass-phrase Juniper@123 encrypt-type des encrypt-pass-phrase Juniper@123

  1. To check the SNMP configuration, use the command show configuration area snmp.

  1. The configuration has been tested in SolarWinds SNMP monitoring tool.

  1. The IP address 192.168.1.221 is the WLC's IP address.

 

Comment on this article > Affected Products Browse the Knowledge Base for more articles related to these product categories. Select a category to begin.

Getting Up and Running with Junos

Getting Up and Running with Junos Security Alerts and Vulnerabilities Product Alerts and Software Release Notices Problem Report (PR) Search Tool EOL Notices and Bulletins JTAC User Guide Customer Care User Guide Pathfinder SRX High Availability Configurator SRX VPN Configurator Training Courses and Videos End User Licence Agreement Global Search