Support Support Downloads Knowledge Base Case Manager My Juniper Community

Knowledge Base

Search our Knowledge Base sites to find answers to your questions.

Ask All Knowledge Base Sites All Knowledge Base Sites JunosE Defect (KA)Knowledge BaseSecurity AdvisoriesTechnical BulletinsTechnotes Sign in to display secure content and recently viewed articles

[ScreenOS] Accessing the Command Line Interface via the Console Port on Your NetScreen, SSG, or ISG Firewall device

0

0

Article ID: KB4066 KB Last Updated: 28 Mar 2019Version: 8.0
Summary:
If your NetScreen firewall contains a RJ-45 console connector, follow the directions below to access the Command Line Interface via the Console Port. 
Solution:
Warning: Use a straight-through RJ-45 CAT5 cable with a male RJ-45 connector to plug in the Console port on the device.

Note:  This procedure is also documented in the Technical Documentation:
  1. Go to Juniper Networks Security Devices
  2. Click the link for your Security Device
  3. Select the Hardware Installation and Configuration Guide (or it may be called Installer's Guide)
  4. Refer to the 'Using a Console Connection' section or 'Establishing a Terminal Emulator Connection' section.

To access the Command Line Interface via the Console port on the Firewall device, perform the following steps:

Note: The Firewall has an RJ-45 port, called the Console port, that allows you to establish a console session with the firewall.
  1. Plug the female end of the supplied DB-9 adapter into the serial port of your workstation. Then plug one end of the RJ-45 CAT5 cable into the DB-9 adapter.
  2. Connect the other end of the RJ-45 cable into the Console port of your Firewall device.

    Image of step two

  3. Launch a serial terminal program, such as HyperTerminal.
    Note: Typical settings to launch a console session with your Firewall are as follows:
    • Baud Rate to 9600
    • Parity to No
    • Data Bits to 8
    • Stop Bit to 1
    • Flow Control to none
  4. From the login prompt, enter your username, and press Enter.  Note: The default login and password is netscreen. Both the login and password are case-sensitive.

    Image of step four

  5. From the password prompt, enter your password, and press Enter.  Note: The password is based on keystrokes. For security purposes, the password is not displayed as it is entered.

    Image of step five

Modification History:
2019-03-28: Removed references to EOS products.

Related Links

Comment on this article > Affected Products Browse the Knowledge Base for more articles related to these product categories. Select a category to begin.

Getting Up and Running with Junos

Getting Up and Running with Junos Security Alerts and Vulnerabilities Product Alerts and Software Release Notices Problem Report (PR) Search Tool EOL Notices and Bulletins JTAC User Guide Customer Care User Guide Pathfinder SRX High Availability Configurator SRX VPN Configurator Training Courses and Videos End User Licence Agreement Global Search