Knowledge Search


×
 

[IDP] Checking Interface Parameters

  [KB4634] Show Article Properties


Summary:
Checking Interface Parameters
Symptoms:

Solution:

To check the parameters of an interface, perform the following steps:

Connect to the IDP Sensor Command Line Interface (CLI).

Set the speed to 100 and full duplex by entering the following command: 
[root@idp1 root]# ethtool -s eth0 speed 100 duplex full

 Verify the settings by entering the following command:

[root@idp1 root]# mii-tool
eth0: 100 Mbit, full duplex, no link
eth1: no link
eth2: no link
eth3: negotiated 100baseTx-FD flow-control, link ok

 Set the speed to 10 and half duplex by entering the following command:

[root@idp1 root]# ethtool -s eth0 speed 10 duplex half

 Verify the settings by entering the following command:

[root@idp1 root]# mii-tool
eth0: 10 Mbit, half duplex, no link
eth1: no link
eth2: no link
eth3: negotiated 100baseTx-FD flow-control, link ok
Related Links: