Support Support Downloads Knowledge Base Case Manager My Juniper Community

Knowledge Base

Search our Knowledge Base sites to find answers to your questions.

Ask All Knowledge Base Sites All Knowledge Base Sites JunosE Defect (KA)Knowledge BaseSecurity AdvisoriesTechnical BulletinsTechnotes Sign in to display secure content and recently viewed articles

NetScreen-1000 Switch Board uses wrong MAC address

0

0

Article ID: KB5248 KB Last Updated: 07 Oct 2008Version: 2.0
Symptoms:
Using original switch board on NetScreen-1000
Mac address get flipped
Packet drops due to mismatch in the MAC address going outbound
NetScreen ARP table shows one MAC address, but debug flow basic shows a different MAC address

Solution:
 
The original switch board that came with the NetScreen-1000 has problems handling MAC addresses where the first bit is higher than 9.  This problem will occur on when communicating with any device with MAC address where the first bit starts with a or higher (in hex). 
 

Workarounds:

  1. If the other network device can change its MAC address, change it so its first bit is between 0-9.
  2. If the above workaround is not possible, upgrade to a Switch II board, which can handle the higher MAC address.

 


Affected Products Browse the Knowledge Base for more articles related to these product categories. Select a category to begin.

Getting Up and Running with Junos

Getting Up and Running with Junos Security Alerts and Vulnerabilities Product Alerts and Software Release Notices Problem Report (PR) Search Tool EOL Notices and Bulletins JTAC User Guide Customer Care User Guide Pathfinder SRX High Availability Configurator SRX VPN Configurator Training Courses and Videos End User Licence Agreement Global Search